PH Tool的参考标准和试验块用于超声波、涡流、磁性微粒及液体渗透测试。可以在管材、棒材、板材、轮、心轴、涡流片、轮毂、抛射体、飞行器外壳、夹具、焊缝、螺栓孔等加工放电加工槽。
PH-TOOL校准模块BASIC4.3.AL介绍及参数
用于建立焊缝UT检查的主要参考响应。Block包含三个侧面钻孔,最小深度为1.5",直径为3/16"。穿过厚度的孔位置是¼,½和¾T。还包含两个EDM槽口,测量2%T深x 1/4"最大宽x 1.0"长min。
ASME基本校准模块旨在代表实际组件,因此在大多数通用测试模块(如IIW或DSC)上没有平滑的扫描表面。相反,在基本校准模块在所有表面上进行了介质喷砂处理,以创建粗糙的表面纹理,这是现实世界检测条件的更多特征。
•尺寸:3"厚 x 6¼"宽 x 9"长
•材质:7075-T6铝,裸机
•可选配木制储物盒
Used for establishment of primary reference responses for UT examination of welds. Block contains three side-drilled holes at 1.5" deep minimum at 3/16" diameter. Hole locations through the thickness are ¼, ½, and ¾T. Also contains two EDM notches measuring 2%T deep x 1/4" max wide x 1.0" long min. In accordance with ASME Sec V Art. 4 Fig. T-434.2.1.
ASME Basic Calibration Blocks are intended to be representative of actual components, and therefore do not have the smooth scanning surfaces found on most general-purpose test blocks like the IIW or DSC. Instead, our Basic Calibration Blocks are media blasted on all surfaces to create a rough surface texture that is more characteristic of real-world inspection conditions.
• Dimensions: 3" thick x 6¼" wide x 9" long
• Material: 7075-T6 Aluminum, bare
• Fitted wooden storage case optional.
PH-TOOL校准模块BASIC4.3.AL
爱泽工业(IZE INDUSTRIES)特价经销、常用PH-TOOL校准模块型号:
PH-TOOL校准模块BASIC4.1.5..SS
PH-TOOL校准模块BASIC4.1.5.A51670
PH-TOOL校准模块BASIC4.1.5.AL
PH-TOOL校准模块BASIC4.1.5.LG.A51670
PH-TOOL校准模块BASIC4.1.5.LG.AL
PH-TOOL校准模块BASIC4.1.5.LG.SS
如果有任何关于PH-TOOL校准模块BASIC4.3.AL的疑问,请随时与我们联系,我们将尽全力解决您的问题。
有关PH-TOOL校准模块BASIC4.3.AL更详细的信息或者购买PH-TOOL校准模块BASIC4.3.AL关产品,请联系爱泽工业。
PH-TOOL校准模块BASIC4.3.AL介绍及参数